NDS Transmission & Gearbox Jack 500kg Hydraulic w Pivot Support Table WT070401

We think this is one of the best Transmission Jacks of its type on the market in New Zealand.

If you are underneath that vehicle... then this machine will make a two man job into an easy One Man operation

Rated at 500kg... which is more than enough for most automobile gearboxes that we know of... this Jack will assist you to remove and of course re-install gearboxes... and Differentials , transfer Boxes and the like to the underside of most vehicles.

Standing on four cast iron wheels the machine stands firm.

The foot operated Jack is exceptionally easy to operate and lifts the saddle of the machine to a height off the ground of 1850mm.

The lowered height is measured as 1200mm to the securing plate or saddle.... and of course the Gearbox/ Diff sits on top of that. 

The raised height is 1985mm to the securing plate or saddle.

The equipment that you are lifting / lowering is secured onto the saddle using an adjustable chain system.

The Saddle is able to be tilted 60 degrees forward and 10 degrees backwards to allow you to line up the gearbox etc.

The Load is lowered via an easy operated hand twist knob to give you precise control.

Please have a look at our online video on You Tube as shown below

A quality machine to make your life easier and Safer!!

If we are delivering to your location , please also note that some lifting may be required when off loading the unit.

For Commercial as well as home use... this lifter will be an asset in your workshop for many years to come.

Assembly is required, and the instruction leaflet is comprehensive but without good English.

Of course.... the Gearbox is not included !!

Approximate Shipping Charges. To be charged after you complete the purchase. We will contact you to confirm address and freight charges.