Red Watch

Tappet/Cam Follower Standard Sold Per Piece  - 143552

Nominal Sizes:
Outside Diameter : 20.30mm
Height: 44.52mm
It is vital that a camshaft & its followers are properly lubricated when installed
and run in an engine for the first time.

Although we sell as a single unit you are advised to normally replace the full set of cam followers when addressing the issue on you engine.
Obviously different engines require different amounts of followers.

These followers are rated for the following engines:
Triumph Herald 1200 from GA11977973E & GD59745E - QTY Required : 8
Triumph Herald 1250 & 1360, from 1965 onwards - QTY Required : 8
Triumph Spitfire Mk2 from FC61023,  - QTY Required : 8
Triumph Spitfire Mk3 - 1296cc Engine - QTY Required : 8
Triumph Spitfire MkIV & 1500 - QTY Required : 8
Triumph Vitesse 1600 from Hb29804E QTY Required : 12
Triumph Vitesse All 2 Litre - QTY Required : 12
Triumph GT6 All Models - QTY Required : 12
Triumph Dolomite & Sprint Model - 1500/1300 OHV- QTY Required : 8
Triumph Mk2 2000/2500/2.5Pi  Six Cylinder Engines  - QTY Required : 12
Triumph TR5-250 6 Cylinder Six Cylinder Engines  - QTY Required : 12
Triumph TR6 Internal Engine  Six Cylinder Engines  - QTY Required : 12

Triumph 2000 Mk1  1965 - 1977 2000cc These engines use smaller cam followers before 1965.

Triumph 2500pi  1968 - 1977 2500cc Includes S and TC variants

Triumph Toledo  1300cc & 1500cc  1970 - 1976

Triumph Dolomite 1300cc      Eng No - DH   1976- 80  

Triumph Dolomite 1500cc      Eng No/ - YC   1976- 80  Not for the Triumph Dolomite 1850 or Sprint

Triumph 1500 FWD     1970 - 1973

Triumph 1500 RWD     1973 - 1976

 Triumph 1300FWD Saloon  1965 - 1970

TVR

TVR Vixen 2.5  1965- 66

MG

MG Midget 1500cc  Dec 1974 - 1979   Check you sill have the correct engine fitted Eng No – FP  Not for any of the earlier Midgets 948cc, 1098cc, 1275c which all had the A-Series engine.