Powerspark Lucas Side Entry Electronic 25D4 Distributor Ford Anglia and Consul with Electronic Ignition Kit & Rotor Arm & Vacuum unit Fitted D16-Powerspark

D16 - Powerspark Ford Anglia and Consul Side Entry Electronic Distributor

Use the pdf Download Icon to see the Standard Installation instructions including MSD 6AL Ignition Control

If the ignition switch is left on without the engine running, a Powerspark ignition kit automatically prevents the coil circuit from remaining energised, helping to avoid component damage and battery drain."
By comparison, a conventional points distributor left with the ignition switched on, and the points closed will continuously draw around 4 amps, overheating the coil and flattening the battery within a few hours. A Powerspark system, however, draws only around 25 milliamps when left on, meaning it could theoretically remain powered for several weeks without flattening the battery, while causing no damage to the coil.

A Lucas 25D distributor with Ford specific drive gear, moulded Powermax rotor arm and side entry (screw underneath) distributor cap.

Used for the Ford Anglia and Consul with a side entry cap.

This cap may well suit other older Fords, so if you are unsure, please contact us.

About Points, Electronic, High Energy and Positive Earth Distributors from Powerspark Ignition:

Traditional Points Distributors:

The traditional ignition system used in most cars up until the 1980s.

- To be used with a Standard or Sports ignition coil, resistance reading above 1.4ohms. OK to use copper HT Leads

Standard Electronic Ignition Distributors (often known as Sports Electronic):

Looks like an original points distributor but contains an electronic ignition module

- To be used with a Standard or Sports ignition coil, resistance reading above 1.4ohms. Not suitable for use with copper HT Leads

- Available as Negative Earth or Positive Earth for most of our distributors and ignition kits.

- To be used with a Standard or Sports ignition coil, resistance reading less than 1.4ohm. Not suitable for use with copper HT Leads