HT Ignition Lead Terminal & Boot Pack for Spark Plug Leads Coil & Distributor Cap on 4 Cylinder IA_4_Cyl_terms

Red Watch

HT Ignition Lead Terminal & Boot Pack for Spark Plug Leads  Coil & Distributor Cap on 4 Cylinder  IA_4_Cyl_terms

Terminal & Boot Pack for Spark Plug Leads to Coil & Distributor Cap on 4 Cylinder HT Leads.  IA_4_Cyl_terms

Terminal & Boot Pack for coil & distributor cap on 4 Cylinder HT Leads.

Useful in converting an acorn or bare terminal lead set for use with a push fit cap upgrade.

Note: This set its not used to create a Spark Plug End Connection

Note these units are good for 7mm & 8mm HT Leads

Use to create your own Silicone or Copper High Tension Plug Lead sets from Distributor Cap and for the Coil Connection to the Distributor

Comprises:

5 x straight push-in cap/coil rubber boots

5 x straight push-in cap/coil brass terminals

5 x 90 degree push-in cap/coil rubber boots

5 x 90 degree push-in cap coil brass terminals

Brass contact spikes 

The longer end fits into the SAE connector that you'll find on the distributor cap or coil, the shorter end crimps onto the cable.
To fit them, first lubricate the inside of the boot and the end of the cable with silicone lube spray.
Then slide the narrow end of the boot over the cable end so you have an inch or two of cable free.
Insert a brass spike into the centre of the cable and bend it back so that half is inserted into the cable and half is bent over the outside of the insulation.
Crimp the terminal onto the cable so that the brass spike is in contact with the terminal with good metal to metal contact.
Slide the boot back over the terminal into the correct position.
There should be a short length of the terminal beyond the end of the boot.

(For the Six Cylinder version of this set please see our listing   IA_6_Cyl_terms )