Terminal & Boot Pack for Spark Plug Leads Coil & Distributor Cap on 6 Cylinder HT Leads. IA_6_Cyl_terms

Stock Status for This Item

Out of Stock; See ETA Tab for arrival date

Red Watch

Terminal & Boot Pack for Spark Plug Leads  Coil & Distributor Cap on 6 Cylinder HT Leads.  IA_6_Cyl_terms
Terminal & Boot Pack for coil & distributor cap on 6 Cylinder HT Leads.
Useful in converting an acorn or bare terminal lead set for use with a push fit cap upgrade.
Note: This set its not used to create a Spark Plug End Connection
Note these units are good for 7mm & 8mm HT Leads
Use to create your own Silicone or Copper High Tension Plug Lead sets from Distributor Cap and for the Coil Connection to the Distributor

Comprises:

7 x straight push-in cap/coil rubber boots
7 x straight push-in cap/coil brass terminals
7 x 90 degree push-in cap/coil rubber boots
7 x 90 degree push-in cap coil brass terminals
Brass contact spikes 

The longer end fits into the SAE connector that you'll find on the distributor cap or coil, the shorter end crimps onto the cable.
To fit them, first lubricate the inside of the boot and the end of the cable with silicone lube spray.
Then slide the narrow end of the boot over the cable end so you have an inch or two of cable free.
Insert a brass spike into the centre of the cable and bend it back so that half is inserted into the cable and half is bent over the outside of the insulation.
Crimp the terminal onto the cable so that the brass spike is in contact with the terminal with good metal to metal contact.
Slide the boot back over the terminal into the correct position.
There should be a short length of the terminal beyond the end of the boot.

( For the 4 Cylinder version of this set please see our listing IA_4_Cyl_terms)